Publicité
SERVICE
REEL REMOVAL AND INSTALLATION
1. Tilt the unit forward and support the rear of the
chassis with jack stands.
Use adequate jack stands when supporting
the unit. Failure to do so may result in
personal injury.
2. Remove the lower belt guard from under the
chassis by removing the screw at the front of the
guard and swinging the guard down.
3. Release the reel clamps E on both sides of the
unit by pulling the clamp levers back.
4. Lower the left end of the reel and remove the
three belts from the pulley at the right end.
Remove the reel. If the blades need to be
replaced, refer to the section on reel blade
replacement.
5. Reinstall the reel in the reverse order of removal.
When reinstalling the reel, make sure the reel
clamps lock "over-center". Failure to do so
may allow the reel to work loose causing
injury to the operator and/or bystanders.
GB-12
MATAWAY
OVERSEEDER
Publicité
