Publicité
Magnification indicator
When you zoom in or out a magnification indicator shows up in the top left corner that
shows what the magnification factor is. This function is turned on by default.
Zoom preset
When this function is on the device will go to the last used magnification in high
constrast modes and photo mode when you switch to these functions. This function is
turned on by default.
Advanced reading aids
This will let you turn reading aids on or off individually.
This function is turned on by default.
Refresh rate / frequency
Depending on your location the mains power frequency will be 50 or 60
Hertz. By selecting the right setting you will suppress flickering caused by
surrounding light. This function is set to 50Hz default.
Contrast
With this function you can turn the manual contrast adjustment on or off.
This function is turned on by default.
White balance
Select whether you want the ability to manually set the white balance in the photo
modes. This function is turned off by default.
On the third and last page of the settings you will find the factory reset, save and exit
and the installed software version.
Factory reset
Activating this function and turning the device off and on again will reset all advanced
i-See Speech
The second screen shows advanced
functions:
Crop zoom
The crop zoom function crops
the image on screen to 50% so
that a zoom level of 1x can be
achieved.
This function is turned off by default.
Sound feedback
When this function is on you
hear a beep when you change a
function. The function is turned
on by default.
functions and last used magnifications
to their default setting. The factory reset
function is a permanent action and can not be
undone.
LED Lightning
The brightness of the LEDs can be adjusted
between values of 0 and 5 (0 indicates the
LEDs are off and 5 indicates the LEDs are at
the brightest level). Please note that reducing
the brightness may result in low image quality,
EN
33
Publicité
