Publicité
4
Use
Turning the device on or off
The on/off switch of the i-See Speech is located at the lower right hand side on the back of the
monitor (see the Controls pictures in chapter 3). To start up or shut down the device, hold it for 2
seconds until you hear the startup or shutdown tone.
During start up the logo appears on the screen and when this disappears, the live image of the
camera is displayed. This is the "Live view mode" of the device. The device is now ready to use.
Switching between modes
The i-See is divided in different modes to get the best performance for the different usage. So it
is possible to set the device to these modes: Live view, Speech and external input.
EN
Press the ON/OFF button once while the device is on, to step between the different modes.
Once a remote control is connected, you can flip the remote control to switch between the Live
view and the Speech mode.
The external input is only available when an HDMI cable is connected to one of the
HDMI ports at the back of the i-See Speech and to an external device (see the Con-
nections picture, chapter 3.). An external device can be a camera or a computer.
The device can be switched to this mode by pressing the power button until the exter-
nal input icon is shown, or by pressing the external input button on the remote control.
5
Live view mode
When you turn on the device it will start in Live view mode. In the Live view you will see the
tableau or the documents on it, which you can use for enlargement or contrast improvement.
Controls
The three buttons (B1, B2 and B3) can be found below the screen and consist of touch sensitive
pads.
Display modes
Tap this icon (B1) to go to the next available display mode.
Press and hold this icon to quickly switch between your last used high contrast mode
and photo mode.
Swipe over this icon from left to right or right to left to go to the next or previous
available display mode. "Photo mode" is the icon with multiple colors (A).
Zoom
Tap or press and hold the minus or plus icon to zoom out or in (B2).
The magnification level will be shown on the screen.
Block auto focus
Tap the magnifier icon to refocus on the reading material and block the auto focus on
that level. Tap a zoom button to unblock the auto focus.
30
For improved feel of the position of these touch sensitive pads,
the i-See Training Doming Label can be pasted over these touch
sensitive pads.
The functions of the three touch sensitive pads are as follows:
B1
B2
B3
B2
i-See Speech
B1
Publicité
