Functions And Description - Tractel blocfor 20R ESD 150 Manuel D'installation

• Check the condition and operation of the connectors:
no visible deformation, opening, closing and locking
possible.
• Check the condition of the associated components
GB
harness and connectors. Refer to the specific
instructions for each component.
• Check the complete fall arrest system.
• Check that the bracket(s) are locked on the tracrod
anchor rod (see § 4.2.2)
• Check that the equipment is in automatic fall arrest
function: the recovery function should not be engaged
before use.
• Check that the lanyard locks when its end is pulled
quickly and that it rolls up and unwinds normally over
its entire length.
• Check that the recovery function engages and
disengages properly.
• Check that the lanyard locks when its end is pulled
quickly and that it rolls up and unwinds normally over
its entire length.

4. Functions and description

4.1. blocfor™ 20R/30R 150 kg
• The self-closing fall arrest system blocfor™ 20R/30R
150 kg is a self-closing fall arrest system in accordance
with EN 360 : see § 4 of the enclosed blocfor™ ESD
- EN 360 leaflet.
• It is equipped with a rescue device by lifting up or
down (EN 1496 class B): recovery function allowing
the rescuer to lift and/or lower the operator after a fall.
It can be used
– vertically when installed on an anchor point.
• This device is disengaged when the blocfor™ is in fall
arrest use.
• After a fall, the mechanism of the blocfor™ is blocked.
To evacuate the operator up or down, engage the
recovery mechanism by pushing the lock button and
then operate the crank.
• The fall arrest system with automatic return blocfor™
20R/30R 150 kg is equipped with two handles to
facilitate its handling and use in rescue by lifting by
holding the equipment handle with one hand and the
crank handle with the other.
• A special anchoring bracket is used to attach the self-
closing fall arrest device blocfor™ 20R/30R 150 kg to
the tracrod anchoring rod.
• The downward rescue function is limited to a
maximum descent of 2 m. Above this height, use a
descender according to EN 341.
5.4
6
5.1
NOTICE FIG.5
5.4
5.2
équerre
5.6
4.2. The console
4.2.1 Installation of blocfor™ 20R/30R on the console
It is prohibited to install a fall arrest device with
automatic return blocfor™ 20R/30R 150 kg on a
console other than that of Tractel.
Preparation of the anchor console
Adapt the position of the bracket to the type of blocfor™
: 20R or 30R.
Position of the bracket to receive a B20R
5.1
NOTICE FIG.5
5.4
Complete console
5.2
Position of the bracket to receive a B30R
5.6
5.3
5.5
2
1
DANGER
équerre
5.5
2
1
5.7
NO
5.2
5.3
3