Publicité
16.6
Check/replace Friction wheel (feed)
The friction surfaces of the wheel become worn over time. If the wear is too worn or damaged, the
wheel must be replaced..
1.
Remove V-Belt
2. Put the lever for the thicknesser planer feed to the lower position (deactiated)
3. Remove the screw for the belt-pulley and replace the wheel and fix it again.
4. Insert V-Belt and re-establish the correct belt tension.
16.7
Check/lubricate Chain-drive (feed)
Check the chain for any damage (cracks, break-outs). The chain can be moved by turning the
friction wheel to view all parts. Lubricate chains with normal machine grease.
16.8
Replacing / adjusting the planing knife
The planer shaft is suitable for strip knives and reversible knives. The machine is
supplied with a strip knife as standard. If the planing surface is bad, the planing knives
must be replaced or regrinded for strip knives. The appropriate dimensions can be
found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
planing shaft! Injuries to hands due to sharp cutting edges
16.9
Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T I C E
W A R N I N G
1.
Adjust the machine to thickness planing mode
2. The dust collection hood must be open in order to have access to
the shaft
3. Loosen the gib screws (1)
4. The planing kife (3) will be pushed up by the pressure springs (5)
5. Remove the gib (2) and the planing knife (3)
6. Clean the planer shaft (4) and gibs (2)
7. Replace sharpend/new planning knife (3) and gib (2)
8. Slightly tighten the gib screws (1) and and perform the
adjustment procedure.
9. Place the setting gauge (6) on the planning shaft and adjust the
correct height.
10. Tighten the gib screws (1) to fix the gib (2) (recommended
minimium tightening torque 20Nm)
11. Do not use planning knives with a height of less than 19mm due
to the too small clamping surface
12. Repeat procedure for all planing knives.
N O T E
45
HOB415_400V
Publicité
