Publicité
Interval
Componente
Anti-kick-back device
Before every
usage
Machine
V-Belt
monthly
Feed/Pull-out roller
Height adjustment
Chain-drive (feed)
Half yearly
Friction wheel (feed)
16.3
Checking/adjusting/replacing the V-Belt
The belt tension is set correctly for new machines ex factory. By stretching the belts over the
running time, retensioning of the belt is necessary.
To check/adjust or replace the belt, remove the belt/chain cover. Loosen the screws and remove
the cover.
Increase belt tension:
Loosen nut (S1) and unscrew slightly. With the
nut (S2) the motor can now be shifted in the
direction (+) of more belt tension.
When correct tension is reached. Tighten the
nut (S1) firmly again.
For changing the V-belt, completely de-tension the belts and pull them over the tension pulleys
and insert new belts. Then establish correct belt tension again.
After completion, remount the cover and fix it with the screws.
16.4 Lubricate height adjustment (thicknesser)
Remove chips and dust from the machine.
Remove the belt/chain cover (loosen the screws and remove the cover).
Lower the thickness planing table completely.
Clean spindle/height adjustment unit and then grease with machine grease.
Move the thickness planing table 1x up and down to distribute the grease.
Mount the cover again (hang in the cover and tighten the screws).
16.5
Check/Clean anti-kick-back device
Check: Lift up Anti-kick back device, it must fall back on your own.
Cleaning: Staub und Späne bzw. Harzreste entfernen.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Activity
At least once per work-shift by inspection to verify
that they are in good working condition, eg have no
impact damages to the surface and that the anti-
kick back device fall back freely due to its own
weight after lifting.
Cleaning (from dust and chips)
Check retighten or replace if necessary.
Check and clean thoroughly
Control, lubrication
Check for damage/wear, lubricate, replace if
necessary
Check for damage/wear and replace if necessary.
Decrease belt-tension:
Loosen nut (S2) and unscrew slightly. With the
nut (S1) the motor can now be shifted in the
direction (-) of less belt tension.
When correct tension is reached. Tighten the
nut (S2) firmly again.
44
HOB415_400V
Publicité
