Publicité
Use the thicknessing function only to reduce the thickness of a workpiece with an already
•
surface planed facing!
For workpieces with a difference in thickness, the chip removal must be measured at the
•
maximum thickness and the workpiece machined with this side first.
Make sure that the workpiece to be machined is free of foreign objects and/or knots in
•
order to avoid dangerous fractures.
Only plane workpieces that rest firmly on the machine and can be guided safely!
•
•
If several workpieces are to be processed in series, all pieces of the same thickness should
be run through in succession without changing the setting.
•
Perform the machining process from the beginning until the desired thickness is achieved.
15.6.1
Converting from planer to thicknessing
For readjusting to planer mode please lower the thicknesser table at least to 140mm
height to avoid any damages.
15.6.2
Thicknessing of workpieces
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Disassemble the angle stop and slide the
• Disassemble the hose of the dust collector
• Unlock clamping lever of the planer table.
• Unfold the planer, take care that the
• Turn down the dust collector hood.
• Mount hose to the dust collector port.
Proceed in reverse order to readjust to the
planer mode.
N O T I C E
• Unlock the table lever (2) and set the required height
of the thicknessing table with the handwheel (1).
• The height will be shonw on the scale (3).
• Set the thicknessing table height to the workpiece
height minus the requested cutting depth.
• Maximum cutting dept refer to the technical data!
NOTE:
At the beginning of the thicknessing process, the
workpieces may still have very different thicknesses - this
must be taken into account in the set cutting depth in
order not to overload the machine.
• Fix the thicknessing table height with the lever (3.
• Press the ON-button to start the machine.
• Put the feeding lever (4) to the upper position to start
the feed.
working direction
• Insert workpiece so that the surface to be machined facing
upwards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and take
on the finished workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
blade cover all the way to the back.
plug.
locking levers engage.
OPERATION
42
HOB415_400V
Publicité
