Publicité
15.3.2
Activating/Deactivating the thicknesser feed rate
15.4
Dust collection port
Do not operate the machine without the dust collection system connected to it and switched on.
The dimensions of the dust collection port can be found in the technical data.
15.5
Planing
The unused part of the planing shaft for machining the workpiece must be covered by
the covers (planer knife cover, guidance planer fence). Never touch the edges of the
workpiece with your fingers, but always leave both hands on the workpiece with your
fingers when planing. If the workpiece is short and narrow, use the sliding wood.
Only plane workpieces that rest firmly on the machine and that can be guided safely!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Activate feed:
Swivel the lever for thicknesser feeder (1) upwards.
Feed is activated
Deactivated feed:
Swivel the lever for thicknesser feeder (1)
downwards. Feed is deactivated.
WARNING
• Press the workpiece against the planer table with one hand.
• Push the workpiece slowly and evenly over the shaft with
the second hand.
• After finishing the operation switch off the machine.
• Wait until the shaft has come to a standstill before
proceeding with any further work!
Planer:
The extraction connection (1) is under the
dressing table (removal table).
Thicknesser:
After the conversion to thickness
planing, fold down the suction hood (2).
• Fix the planer fence (1) in the
desired working position.
• Set the desired planing
thickness on the adjusting
screw (3).
• Adjust the planer knife cover
(2) so that the distance
between the cover and the
workpiece is approx. 5mm.
• Start machine
working direction
OPERATION
40
HOB415_400V
Publicité
