Publicité
•
In the case of resin residues on the wood, it may be advisable to apply a thin
layer of a special lubricant to the machine table in order to ensure that the
workpiece slides evenly through the thickness planer.
If the workpiece is no longer moved by the automatic feed, pull out the
•
workpiece manually.
After operation switch off the machine and set the lever for thicknesser feeder
•
to position "OFF".
Before further activities wait until blade shaft is at a standstill!
•
15.7
After working process
After the working process the planer and thicknesser must be turned off:
Switch off the machine and disconnect the machine from the power supply.
•
•
After operation set the lever for thicknesser feeder to position "OFF".
Adjust the planer knife cover so that the planer shaft is completely covered
•
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
•
Remove chips and dirt particles from the machine after each use with a proper tool.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
•
(e.g. WD40 rust inhibitor).
16.2
Maintenance
The machine is low maintenance and only a few parts require maintenance. Malfunctions or
defects that are likely to impair your safety must be rectified immediately!
•
Check that the safety devices are in good condition before each operation.
Check the connections at least once a week for a tight fit.
•
Check the correct and readable status of the Machine's warning and safety labels on a
•
regular basis.
16.2.1
Maintenanceplan
Wear of machine depends strongly on operation condition. The following intervals are valid when
using the machine within the operation limits
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T E
N O T E
W A R N I N G
N O T E
43
HOB415_400V
Publicité
