Publicité
15.2
Settings
The alignment of the planer fence at right angles should be checked again
before initial operation and readjusted if necessary to achieve an exact
planing result.
15.3
Operation
15.3.1
Switch the machine on and off
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1. Height adjustment of the planing tables
Entry planer table
The cutting depth is set with the adjustment knob
planer cutting depth (1)
Exit planer table
The height of the back planer table can be adjusted
with the adjusting screw and should only be adjusted
to the planer shaft if necessary.
Check scale knife entry planer table = 0
If necessary, adjust the arrow of the scale
2. Setting arm and planer knife cover
Height
Planer knife cover
3. Setting planer fence
• The angle is measured with a protractor (8). This is placed on the planer
table and applied to the planer fence.
• If it is not possible to place the protractor completely against the planer
fence, the planer fence is not set exactly at right angles and an
adjustment is necessary.
• The angle is adjusted with the screw (5).
Switch on
Push green ON-button (1)
Switch off
Push red OFF-button (2)
• Set the desired height with the adjusting screw (2)
• Loosen the clamping screw (3)
• The planer knife cover can be moved and adapted
to the size of the workpiece
• Relock the clamping screw (3) when the desired
position is reached.
• Loosen clamping lever (4)
• Set planer fence to the desired position
• Relock the clamping lever (4) when the desired
position is reached.
OPERATION
39
HOB415_400V
Publicité
