Publicité
Dryer Control
General Washer/Dryer User Information
NOTE: After the washer/dryer has been installed and plugged
in, the display will show "0 MINUTES" on the washer and dryer
portions of the display. After the washer and dryer doors have
been opened and closed, the display will show the price for
each machine. On washer/dryers set for free cycles, the display
sections will flash "SELECT CYCLE".
1. PD Models: Insert coins until "SELECT CYCLE" flashes on
the display portion of the washer or dryer that is to be run.
PR Models: A debit card is required rather than coins.
Generation 1 or 2 debit card systems may be used; but
when the Generation 2 debit system is used, the controls
will automatically be set to Enhanced Debit mode (J. Ed).
In Enhanced Debit mode, the card balance will also display
when a debit card is inserted into the reader.
2. Door must be closed on the desired washer/dryer before
cycle selection is made.
3. Press the fabric setting button for the washer/dryer cycle
desired. After the cycle is started, the time will display and
count down.
4. If a cycle is interrupted by opening the door or power loss,
"RESELECT CYCLE" will flash in the display. To restart the
washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle
will cancel if the door is opened.
Scrolling 'out of order' message, followed by a failure or
diagnostic code, showing in display
This condition indicates an error has been detected. Refer to
Fault Codes for diagnostic information.
"0 MINUTES" SHOWING IN DISPLAY
This indicates the previous cycle is complete or a machine reset
was performed. Opening the door will restore the display to the
vend price or available state.
Factory Default Setting
Washer is programmed at the factory as follows:
■ Normal and Delicates cycles have an 11 minutes wash period
and 2 rinses, with the option of an extra rinse.
■ The Powerwash cycle has 3 minutes of Prewash, a 14
minutes wash period and 4 rinses, with the option to deselect
the extra rinse.
■ $1.75 wash price for Normal and Delicates cycles, $2.00 for
Powerwash (PD models).
■ $0.00 wash price (PR models).
Dryer is programmed at the factory as follows:
5 minutes dry time/ coin or debit pulse
$1.50 dry price (fixed cycle with top off - PD Models)
$0.00 dry price (fixed cycle - PR Models)
Warm Start (after power failure)
A few seconds after power is restored, if a cycle was in progress
at the time of the power failure, "RESELECT CYCLE" will flash in
the display, indicating the need for a key press to restart washer
or dryer.
Washer Door Lock
Prior to beginning a cycle, there is a door lock routine of
lock/unlock/relock, then cycle begins. The door will remain
locked until the end of a cycle or approximately 2 minutes after a
power interruption.
Pricing
After the door is opened following the completion of a cycle, the
display indicates the cycle price (unless set for free operation). As
coins are inserted or debit inputs arrive, the display will change to
acknowledge valid coin or debit inputs.
There are four (4) types of dryer pricing:
Fixed "Vend" Pricing
A dryer setup for "Fixed Cycle" operation can only accept
additional time accumulated by increments equal to the length
of a complete dry cycle. A maximum of 75 minutes may be
purchased; no additional credit is given for coins dropped with
75 minutes in the display.
Accumulator Pricing
If the price is set to one Coin 1, then accumulator pricing is
in effect. Cycle time can be purchased one coin at a time (PD
models) up to the maximum time of 75 minutes.
Fixed Cycle With Top Off Pricing
A dryer set to offer "Top Off" capability will allow time to be
added to an existing dry cycle in increments equal to the number
of minutes of dry time per Coins or Debit inputs, up to 75
minutes, regardless of the cost required to start the dryer. No
credit is given for coins or debit inputs entered when the control
is displaying 75 minutes.
29
Publicité
