Publicité
4. U.S.A MODELS and CANADA GAS:
Models with separate washer power cords: Push the power
cord plug into the opening on the right side of the rear panel
and pull the power cord through the opening on the left side
of the rear panel and close holes with the attached cap. Do
not pull plug end of power cord through the right side hole.
NOTE: To avoid damage to internal washer parts or the power
cord, if the cord does not pull out of the washer rear panel
easily, do not force it. Remove the washer rear panel and
guide the power cord around the obstruction and out the hole
on the left side of the rear panel.
5. Close the bolt holes with the four transport bolt hole plugs.
IMPORTANT: If the washer/dryer is to be transported, call
your product distributor or installer. To avoid suspension and
structural damage, your washer/dryer must be properly set up for
relocation by a trained professional.
Connect Inlet Hoses
Insert new hose washers (supplied) into each end of the inlet
hoses. Firmly seat the washers in the couplings.
Washer
Coupling
Connect inlet hoses to water faucets
Make sure the washer drum is empty.
1. Attach a hose to the hot water faucet. Screw on coupling by
hand until it is seated on the washer.
2. Attach a hose to the cold water faucet. Screw on coupling by
hand until it is seated on the washer.
3. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve.
Damage to the valves can result.
Clear water lines
■ Run water through both faucets and inlet hoses, into a laundry
tub, drainpipe, or bucket, to get rid of particles in the water
lines that might clog the inlet valve screens.
■ Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
Connect inlet hoses to washer
1. Attach the cold water hose to the washer's cold water inlet
valve. Screw on coupling by hand until it is seated on the
washer.
17
Publicité
