Publicité
4. Secure the drain hose using the supplied beaded tie strap.
5. If the washer faucets and the drain standpipe are recessed,
put the hooked end of the drain hose in the standpipe as
shown.
NOTES:
■ Do not force excess drain hose back into the rear of the
washer.
■ To avoid siphoning, do not seal the drain hose into the
standpipe.
■ It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.
WASHER DRAIN SYSTEM
The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain
system.
Standpipe drain system – wall or floor
The standpipe drain requires a minimum diameter standpipe of
2" (50 mm). The minimum carry-away capacity can be no less
than 10 gallons (38 L) per minute.
Wall
The top of the standpipe must be at least 30" (762 mm) high and
no higher than 96" (2.4 m) from the bottom of the washer.
Floor
30" minimum
(762 mm)
Laundry tub drain system
The laundry tub needs a minimum 20 gallons (76 L) capacity. The
top of the laundry tub must be at least 30" (762 mm) above the
floor.
30" minimum
(762 mm)
Floor drain system
The floor drain system requires a siphon break that may be
purchased separately.
The siphon break (Part Number 285834) must be a minimum of
28" (710 mm) from the bottom of the washer. Additional hoses
might be needed.
A
28" minimum
(710 mm)
A. Siphon Break
ELECTRIC DRYER ELECTRICAL
CONNECTIONS-USA ONLY
Connection Options
NOTE: If local codes do not permit connection of a
cabinet-ground conductor to neutral wire, go to "Connecting
3-Wire Connection: Optional" section. This connection may be
used with either a power supply cord or a direct wire connection.
Power Cord
4-wire receptacle (NEMA Type 14-30R)
Go to "Power Supply Cord Connection" section.
19
Publicité
