Publicité
Reverse the Strike
1. Use a small flat-blade screwdriver to remove the plug strip
from the dryer door opening. Slide the head of the screwdriver
under the plugs, without scratching the dryer surface, and lift
up the strip.
2. Remove the strike using a Phillips screwdriver.
3. Insert strike on the opposite side.
Reinstall the Door
1. Partially insert the third screw from the top; then slide the
hinge onto this screw while hooking the hinge into the front
panel hole. Reattach door to dryer front panel with the
remaining three screws.
2. Check for fingerprints on the glass. Clean if necessary.
3. Close door and check that it latches securely.
STACKED WASHER/DRYER
MAINTENANCE INSTRUCTIONS
Washer
Cleaning the Door Seal/Bellow
1. Open the washer door and remove any clothing or items from
the washer.
2. Inspect inner glass door. If debris is present, wipe it off using
a damp cloth.
3. Inspect the colored seal/bellow between the door opening
and the basket for stained areas. Pull back the seal/bellow to
inspect all areas under the seal/bellow and to check for
foreign objects.
A. Seal/Bellow
4. If stained areas are found, wipe down these areas of the seal/
bellow:
a. Mix a dilute solution, using 3/4 cup (177 mL) of liquid
chlorine bleach, and 1 gallon (3.8 L) of warm tap water.
b. Wipe the seal/bellow area with the dilute solution, using a
damp cloth.
c. Let stand 5 minutes.
d. Wipe down area thoroughly with a dry cloth and let the
washer interior air dry with door open.
IMPORTANT:
■ Wear rubber gloves when cleaning for prolonged periods.
■ Refer to the bleach manufacturer's instructions for proper use.
Maintenance Instructions:
This washer has a special cycle that uses higher water volumes
in combination with liquid chlorine bleach to thoroughly clean the
inside of the washer.
NOTES:
■ Read these instructions completely before beginning the
cleaning process.
■ If necessary, the cleaning cycle may be interrupted by
pressing the Start button twice. However, this will not
immediately stop the cycle. The washer will continue with
several rinse and drain steps to ensure that all remaining
bleach is rinsed from the washer.
To clean washer interior:
1. Open the washer door and remove any clothing or items from
the washer.
2. Use liquid chlorine bleach:
Open the dispenser drawer and immediately add 2/3 cup
(160 mL) of liquid chlorine bleach to the bleach compartment.
NOTE: Do not add any detergent. Use of more than 2/3 cup
(160 mL) of bleach will cause product damage over time.
A
27
Publicité
