Product Operation
Water Filtration System
The water filtration system supplies filtered water to the ice
maker and water dispenser (dispenser models) to produce
great-tasting water and ice.
IMPORTANT NOTE: When using the water filtration system
for the first time and after filter replacement, it is neces-
sary to clear any air from the system and allow the filter
to assist in cleaning the water lines. For non-dispenser
models, discard the first two full bins of ice. For dispenser
models, dispense several glasses of water for a period of
two minutes.
If the water filtration system will not be used, it can be
placed in water filter bypass mode by removing the filter.
"Snooze/Refresh" appears on the control panel when the
filter needs to be replaced. Touch "Snooze" to delay the
reminder for 24 hours or until the filter can be replaced.
Replacement Sub-Zero water filters can be ordered online
at subzero.com/store. For questions, contact Sub-Zero
Customer Care at 800-222-7820.
16 | Sub-Zero Customer Care 800.222.7820
To replace the water filter:
1
To access the water filter, pull out on the bottom edge
of the grille and rotate upward. Refer to the illustration
below.
To remove the old filter, rotate counterclockwise
2
one-quarter turn, then pull out. It is normal for a small
amount of water to drip when the filter is removed.
Remove the new filter from packaging and remove the
3
plastic cap.
Insert the new filter into the manifold and turn clock-
4
wise.
5
Follow the instructions on the control panel. The filter
life cycle resets for approximately one year.
WATER FILTER
Water filter removal