gaviota Kyma Manuel D'installation page 63

(All the example assembly images are a Type 4 configuration with motor to the right).
c. Mount the connection flanges to this charge profile. Introduce them half their
length and tighten the three DIN7380 M6x8 screws on each one of them
(which are inside the profile guides) with a no. 4 Allen key.
d. Then, introduce the piece that covers the connection flange of the
two profiles.
All dimensions in mm, unless otherwise stated.
e. Introduce the second profile in the canvas and place it in position. Match up
the connection flanges and the piece that covers the profile flange, and
tighten the six DIN7380 M6x8 screws with a no. 4 Allen key.
Step 58. (Common)
Assemble the covers for the supports and fix
the canvas
a. Introduce the canvas on the profile groove
and place the S7 dowel in each side.
b. Assemble and attach the supports of the charge profile covers and canvas,
with three DIN7981 4.2x25 screws on each side and a Phillips screwdriver.
COVER FIXATION
KÝMA
CANVAS FIXATION
63