gaviota Kyma Manuel D'installation page 54

KÝMA
FOR TYPE 3, 4, 5 AND 6 CONFIGURATIONS, GO TO STEP 33
Step 29. (Type 1 and 2)
Mount the box that was previously set-up in the workshop to the wall support.
Step 30. (Common)
To secure the box, assemble the clamps, taken off in Step 28, with two
DIN912 M6x25 screws and two DIN 125 M6 washers with a no. 5 Allen key.
Do not tighten.
54
DO NOT TIGHTEN
THE CLAMP
Step 31. (Type 1 and 2)
Align the box supports to the wall, with the arm supports placed in their correct
location in Step 11. Once correctly aligned, attach by tightening the clamps
from Step 30, with a no. 5 Allen key.
+
5 -
TIGHTEN
Step 32. (Common)
Place the clamp screw caps.
+
5 -
TIGHTEN
All dimensions in mm, unless otherwise stated.