gaviota Kyma Manuel D'installation page 59

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

(All the example assembly images are a Type 4 configuration with motor to the right).
Step 45. (Type 3, 4, 5 and 6)
Thread the motor's cable through the hole indicated in Step 5. In Type 5 and
6 configurations with two motors, this step will also be carried out on the
left-side motor.
Motor cable and illumination
cable outlet
Step 46. (Type 3, 4, 5 and 6)
Centre and attach the box set on the wall supports. Tighten the support clamps
once the box set is centred with two DIN912 M6x25 screws and two DIN125 M6
washers per support with a no. 5 Allen key.
All dimensions in mm, unless otherwise stated.
Step 47. (Type 3, 4, 5 and 6)
Mount the arm supports, respecting the support bracket and the arm bracket,
which supports the box profiles. Attach the arm supports to the connectors
mounted on the box profiles in Steps 36 and 40 with two DIN7991 M8x16
screws in each support, with a no. 5 Allen key.
+
+
5 -
5 -
Step 48. (Type 3, 4, 5 and 6)
Mount the frontal profiles which were cut following Table L. Clip the PVC profile
to the aluminium profile, as indicated in the image.
Do not assemble for PVC fabrics.
Do not match the joint of the aluminum profiles with the PVC lyre profiles.
KÝMA
+
+
5 -
5 -
59

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières