gaviota Kyma Manuel D'installation page 49

Step 12. (Common)
a. Assemble the connectors in the front terminals of the arms. In case of a
Type 2 configuration, with two DIN912 M8x50 screws, DIN917 M8 nuts and a
no. 6 Allen key. Once tight, place the screw cap.
b. Correct assembly of the connectors to the arms (upper view)
Left arm + Left connector
Step 13. (Common)
Mount the arms on the arm supports already assembled, respecting the
support bracket and the arm bracket. If this is a Type 2 configuration, do the
same in the middle support and the third arm, respecting the support bracket
and the arm bracket. Attach with the fixation axis and DIN914 M8x12 screw,
one in each support with a no. 4 Allen key.
All dimensions in mm, unless otherwise stated.
Right arm + Right connector
Step 14. (Common)
a. Regulation of the elbow height on the arms. Close the arms with your hand
as much as necessary to access the screw in the front part of the arm
support. Use your hand and a no. 4 Allen key. This step will be carried out in
each one of the arms in the configuration.
b. By tightening the screw, the elbow goes up. By untightening the screw, it
comes down.
Step 15. (Common)
Assemble the mat in the box's upper profile.
Assemble the mat in the indicated groove.
KÝMA
If the Concept arms are being assembled
with light, the cable will thread through
the side of the box through this space.
49