gaviota Kyma Manuel D'installation page 61

(All the example assembly images are a Type 4 configuration with motor to the right).
Step 52. (Common)
a. Regulation of the elbow height on the arms. Close the arms with your hand
as much as necessary to access the screw in the front part of the arm
support. Use your hand and a no. 4 Allen key. This step will be carried out in
each one of the arms in the configuration.
b. By tightening the screw, the elbow goes up. By untightening the screw, it
comes down.
Step 53. (Common)
Assemble the mat in the box's upper profile
Assemble the mat in the indicated groove.
All dimensions in mm, unless otherwise stated.
If the Concept arms are being assembled
with light, the cable will thread through the
side of the box through this space.
Step 54. (Type 3, 4, 5 and 6)
a. Mount the box's upper profile joining flange on one of the front profiles.
b. Introduce the flange completely in one of the profiles (the left one, in
this case)
Step 55. (Type 3, 4, 5 and 6)
a. Mount the box's upper
profile to the box.
KÝMA
Assemble the flange in the indicated groove
Detail of the upper profile assembly
61