KÝMA
(All the example assembly images are a Type 4 configuration with motor to the right).
f. In Type 3, 4 and 5 configurations with a 40 motor,
mount the canvas, the round cap to the Ø85 joined
axis. The plastic bearing is code 40060879.
g. In Type 5 and 6 configurations with two motors, mount the canvas to the
Ø85 axis and the motor of the side on which the side support has already
been installed in Step 34. (In this example, the left one.)
h. The position of the canvas on the Ø85
axis for Type 5 and 6 configurations
with two motors is equidistant to
both sides.
Step 42. (Type 3, 4, 5 and 6)
Mount the motor on the side supports that is not attached to the box profile
(in this example, the right one) with two DIN7991 M6x25 screws using a no. 4
Allen key.
58
Step 43. (Type 3, 4, 5 and 6)
40
Step 44. (Type 3, 4, 5 and 6)
=
=
Mount the assembled set in Step 41 to the Ø85 axis.
Mount the box to the Ø85 axis set assembled in Step 43. After attaching the
left side of the axis (as per this example), screw in the right-side support to
the box profile with three DIN7981 4.2x25 self-drilling screws with a Phillips
screwdriver.
•
In Type 3, 4 and 5 configurations
with one motor, this step's
assembly is done.
•
In Type 5 and 6 configurations with two motors, the motor from the other
side must be attached (in this example, the one on the left) with two
DIN7991 M6x25 screws using a no. 4 Allen key, as in Step 42.
All dimensions in mm, unless otherwise stated.