gaviota Kyma Manuel D'installation page 60

KÝMA
(All the example assembly images are a Type 4 configuration with motor to the right).
Step 49. (Type 3, 4, 5 and 6)
Do not assemble for PVC fabrics.
a. Introduce the frontal profile sets to the box profile.
b. Assembly steps of the frontal profile set.
c. Align the frontal profile set correctly
with the holes of the side supports as
shown in the image.
d. Fix the frontal profile set to the
box sides with two DIN7981
4.2x25 screws per side with a
Phillips screwdriver.
60
Step 50. (Common) (Common)
a. Assemble the connectors in the front terminals of the arms, respecting the
arm bracket and the connector bracket, with two DIN912 M8x50 screws and
DIN917 M8 nuts, with the no. 6 Allen key. Once tight, place the screw cap.
b. Correct assembly of the connectors to the arms (upper view)
Left arm + Left connector
Step 51. (Common)
Mount the arms on the arm supports already assembled, respecting the
support bracket and the arm bracket, respecting the support bracket and the
arm bracket. Attach with the fixation axis and DIN914 M8x12 screw, one in
each support with a no. 4 Allen key.
Right arm + Right connector
All dimensions in mm, unless otherwise stated.