gaviota Kyma Manuel D'installation page 50

KÝMA
Step 16. (Common)
Assemble the upper profile in the box profile, cut following Table L, with two
DIN7981 4.2x25 screws, one per side, and a Phillips screwdriver.
Detail of the upper profile assembly
Step 17. (Common)
Join the charge profile, cut following Table L, to the canvas. Introduce the
canvas on the profile groove and place the S7 dowel in each side.
50
Step 18. (Type 1)
Assembly of the components attached to the charge profile. Introduce the
components seen in the image in the indicated order.
LEFT
Step 19. (Type 2)
In a three-arm configuration: Assemble the components for the third arm to
the charge profile considering if it is a right or a left arm.
Example of a Type 2 configuration with two left arms and one right
FOR TWO LEFT ARMS
RIGHT
FOR ONE RIGHT ARM
All dimensions in mm, unless otherwise stated.