gaviota Kyma Manuel D'installation page 46

KÝMA
Step 2. (Type 1 and 2)
Mount the canvas tube assembled in the prior step inside the box profile, which
was cut following Table L.
Step 3. (Common)
Introduce the fixing connectors of the arm supports in the indicated profile
groove. For Type 1, two units; for Type 2, three units.
46
Groove where connectors
are introduced
Step 4. (Common)
Mount the two side supports and the motor/point mounts, one on the right and
one on the left, with two DIN912 M8x16 screws and two DIN127 M8 washers in
each support, using a no. 6 Allen key.
All dimensions in mm, unless otherwise stated.