gaviota Kyma Manuel D'installation page 56

KÝMA
(All the example assembly images are a Type 4 configuration with motor to the right).
Step 38. (Type 3, 4, 5 and 6)
Mount this first box profile to the wall support; in this case, to the two left-most
supports already on the wall. Attach the support clamps, without tightening,
with two DIN912 M6x25 screws and two DIN125 M6 washers, using a no. 5
Allen key.
56
Step 39. (Type 3, 4, 5 and 6)
Assemble the second box profile on the two free supports on the right side
following the steps before, and place the clamps on the supports without
tightening.
Tighten the rest of the connector screws inserted in Steps 36 and 37 with two
no. 3 and 5 Allen keys once the connectors have been placed on the box profile.
DO NOT TIGHT-
EN THE CLAMP
DO NOT TIGHTEN
THE CLAMP
All dimensions in mm, unless otherwise stated.