Publicité
5) If the cutting disc jams or you stop
working, switch the tool off and
hold it steady until the disc has
completely stopped turning. Never
attempt to pull a rotating cutting
disc out of a cut. This could lead to
kickback. Identify and remove the cause
of the jam.
6) Do not switch the power tool back
on while it is still in the workpiece.
Allow the cutting disc to reach its
full speed before you carefully
resume the cut. Otherwise, the disc may
jam, jump out of the workpiece or cause
kickback.
7) Support panels or large workpieces
to reduce the risk of the cutting disc
jamming and causing a kickback.
Large workpieces can bend under their own
weight. The workpiece must be supported on
both sides, namely in the vicinity of the cut,
and also at the edge.
8) Be particularly careful when
making "pocket cuts" into existing
walls or other obscured areas.
The inserted cutting disc may cut into gas
or water pipes, electrical wiring or other
objects that can cause kickback.
38 GB/IE
Supplementary safety
instructions for working with
wire brushes
Special safety instructions for working
with wire brushes
1) Be aware that the brush can lose
wire bristles even during normal
operation. Do not overstress
the wires by applying excessive
pressure to the brush. The wire bristles
can easily penetrate light clothing and/or
skin.
2) Allow the brush to run at working
speed for at least one minute
before applying it to the workpiece.
Ensure that no one is standing in
front of or in line with the brush
during this time. Loose pieces of wire
can fly off during the run-in period.
3) Aim the rotating steel brush away
from yourself. When working with these
brushes, small particles and minute pieces
of wire can fly off at great speed and pierce
skin.
Vibration and noise
reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as well
as wear personal protective equipment.
Take the following points into account to
minimise the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions.
Ensure that the product is in good condition
and well maintained.
Publicité
