Publicité
Tethering the bouncy castle
Fasten the product securely at the eight fastening
loops (1a) using one peg (8) each on an even
grass surface (fig. A).
Dismantling
Deflating
Deflate the castle as follows:
1. To deflate the floor chamber quickly, open the
seal (fig. D).
2. To deflate the other components pull out the
respective valve and squeeze the valve stem
lightly so that the air can escape or insert
the deflation tube (9) into the corresponding
stopper to let the air escape rapidly.
Storage, cleaning
When not in use, always store the product clean,
dry, and not inflated at room temperature.
The valves should always be closed during
storage. Clean the product only with water or
soapy water, never with abrasive detergents.
When storing for the winter do not place any
sharp-edged objects on the product and do not
powder with talc.
Repairs
Small leaks or holes can be repaired with the
repair patches (10) supplied.
Important! After repair do not inflate
the product for 20 minutes! Do not
use the patch for leaks or holes on the
seam.
• Allow the air to escape from the product
completely.
• Clean the area around the leak thoroughly!
The area must be dry and free of grease.
• Cut out a piece of repair material big enough
to have its edges protruding about 1.3cm over
and beyond the damaged area.
• Pull the patch off the paper, place it on the
damaged area, and press it down firmly.
6
GB/IE/NI
Disposal
Dispose of the product and packaging
materials in accordance with current
local regulations. Store the packaging
materials (foil bags, for example) out of
the reach of children. For further information
about disposal of the product no longer needed,
contact your local council. Dispose of the
product and the packaging in an environmental-
ly friendly manner.
The Recycling Code distinguishes
different materials to be returned for
recycling. The Code consists of the
recycling symbol for the recycling process and a
number that identifies the material.
Notes on the guarantee and
service handling
The product was produced with great care and
under continuous quality control. DELTA-SPORT
HANDELSKONTOR GmbH gives private end
customers a three-year guarantee on this product
from the date of purchase (guarantee period)
in accordance with the following provisions.
The guarantee is only valid for material and
manufacturing defects. The guarantee does not
cover parts subject to normal wear and tear that
are thus considered wear parts (e.g. batteries)
or fragile parts such as switches, rechargeable
batteries, or parts made of glass.
Claims under this guarantee are excluded if the
product has been used incorrectly, improperly,
or contrary to the intended purpose, or if the
provisions in the instructions for use were not
observed, unless the end customer proves that
a material or manufacturing defect exists that
was not caused by one of the aforementioned
circumstances.
Claims under the guarantee can only be made
within the guarantee period by presenting the
original sales receipt. Please therefore keep the
original sales receipt. The guarantee period is
not extended by any repairs carried out under
the guarantee, under statutory guarantees, or
as a gesture of goodwill. This also applies to
replaced and repaired parts.
Publicité
