Publicité
• The surfaces must always be clean and dry.
• Inform your children regarding the instructions
for use so that they play safely.
• The bouncy castle may not be used as a bed
because children might slip between the floor
and side walls and suffocate.
Avoiding material damage!
• All inflatables are susceptible to cold. For this
reason never unfold and inflate the product at
a temperature lower than 15°C!
• In the event that the air pressure increases in
the hot sun, it must be balanced accordingly
by letting out air.
• Make sure that the product, especially when
inflated, does not come into contact with
stones, gravel, or sharp objects and does not
rub or scrape against anything; this can cause
damage to the plastic foil.
• Use only the correct pump adapters to insert
into the safety valves. The valves might other-
wise become damaged.
• Do not over-inflate because you then risk tear-
ing open the welded seams. Close the valves
properly after inflating.
• Avoid contact with sharp, hot, pointed, and
dangerous objects.
Assembly
Assembly should always be undertak-
en by an adult. Follow the individual
assembly steps in the order indicated.
• Choose an even and clean surface with
enough room to unpack and unfold the castle.
• Check that all the individual parts are there
and in good order and condition.
• After assembling for the second time you
should check the bouncy castle for any dam-
age, holes and tears and seal them.
Inflation
Warning!
• Always inflate the air chambers com-
pletely!
• Avoid inflating the air chambers too
much because there is the risk of
over-stretching the welded seams and
even tearing them open.
• To inflate the product use standard
commercial foot pumps or dou-
ble-stroke piston pumps with the
appropriate pump adapters.
• To inflate the product do not use a
compressor or compressed air bottles.
This can lead to damage to the prod-
uct.
• Make sure that the chambers are
evenly inflated.
• Inflate each air chamber until it feels
firm. When you press with your
thumb against the air chamber it
should still give a little.
• WARNING! Avoid using sunscreen
and skin care products containing
alcohol. Sunscreen and skin care
products containing alcohol can cause
the colour coating of this PVC inflata-
ble product to peel. This can lead to
stains on your body, your clothing,
and other objects that are in contact.
Sequence
WARNING!
Follow the correct sequence when inflat-
ing the air chambers. Always inflate all
air chambers fully.
1. Floor chamber (1)
2. Side arches (2)
3. Side walls (3)
4. Longitudinal struts (4)
5. Basketball basket and target board (7)
Inflation
1. Open the valve on the bottom of the floor
compartment (1).
2. Fill the floor chamber with air and close the
cap (fig. C). Inflate the air chamber until it
feels firm. When you press with your thumb
against the air chamber it should still give
a little. Close the valve seal and push in the
valve by pressing gently.
3. To fill components (2)-(7) open the valve seal
and inflate the air chambers (fig. B). Close the
valve seal and push in the valve by pressing
gently.
GB/IE/NI
5
Publicité
