Publicité
Fig.3
1
Lamp switch
5
Set plate
9
Releasing button (for
bevel angle)
INSTALLATION
Bench mounting
WARNING:
Ensure that the tool does not
move on the supporting surface. Movement of the
miter saw on the supporting surface while cutting may
result in loss of control and serious personal injury.
1.
Fix the base to a level and stable surface, screwing with
the bolts. This helps to prevent from tipping and possible injury.
Fig.4
► 1. Bolt 2. Mounting hole
2
3
4
5
2
Shaft lock
6
Hex wrench
-
-
1
2
1
6
3
Adjusting bolt (for maxi-
mum cutting capacity)
7
45° adjusting bolt (for
bevel angle)
-
-
2.
Turn the adjusting bolt clockwise or counterclock-
wise so that it comes into a contact with the floor sur-
face to keep the tool stable.
1
Fig.5
► 1. Adjusting bolt
7 ENGLISH
7
8
9
4
Stopper pin (for carriage
elevation)
8
Lever (for bevel angle)
-
-
Publicité
