Publicité
4.
Install the outer flange and hex socket bolt.
Tighten the hex socket bolt (left-handed) counterclock-
wise securely using the hex wrench while pressing the
shaft lock.
1
2
Fig.28
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Circular saw blade 4. Inner flange 5. Spindle
1
Fig.29
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Shaft lock
5.
Return the blade guard and center cover to its
original position. Then tighten the hex socket bolt of the
center cover to secure it.
Lower the carriage and check that the blade guard
moves properly.
1
2
Fig.30
► 1. Hex wrench 2. Hex socket bolt 3. Center cover
4. Blade guard
3
4
5
3
2
4
3
Removing the circular saw blade
1.
Complete the steps in the "Common preparations
for installing or removing the circular saw blade".
2.
Press the shaft lock to lock the spindle. Loosen
the hex socket bolt clockwise using the hex wrench.
Then remove the hex socket bolt, outer flange and
circular saw blade.
Fig.31
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Shaft lock
3.
If the inner flange is removed, install it on the spin-
dle with its blade mounting part facing the circular saw
blade. If the flange is installed incorrectly, the flange will
rub against the machine.
1
Fig.32
► 1. Hex socket bolt (left-handed) 2. Outer flange
3. Circular saw blade 4. Inner flange 5. Spindle
NOTICE:
Be careful not to lose the removed outer
flange and hex socket bolt.
16 ENGLISH
3
1
2
3
2
4
5
Publicité
