Publicité
3.
Rotate the circular saw blade by hand while
holding the handle all the way down to be sure that
the circular saw blade does not contact any part of the
lower base. Re-adjust the maximum cutting capacity, if
necessary.
WARNING:
After installing a new circular saw
blade and with the tool is unplugged, always be
sure that the circular saw blade does not contact
any part of the lower base when the handle is
lowered completely. If the circular saw blade con-
tacts with the base, it may cause kickback and result
in serious personal injury.
Fig.16
Stopper arm
The lower limit position of the saw blade can be easily
adjusted with the stopper arm. To adjust the lower limit,
turn the stopper arm in the direction of the arrow as
shown in the figure. Turn the adjusting screw so that the
saw blade stops at the desired position when lowering
the handle fully.
2
1
Fig.17
► 1. Stopper arm 2. Adjusting screw
Adjusting the miter angle
CAUTION:
After changing the miter angle,
always secure the turn base by tightening the grip
firmly.
NOTICE:
When turning the turn base, be sure to
raise the handle fully.
Rotate the grip counterclockwise to unlock the turn
base. Turn the grip while holding up the lock lever to
move the turn base. Align the pointer with your desired
angle in the miter angle scale then tighten the grip.
Fig.18
► 1. Lock lever 2. Grip 3. Pointer
Positive stop function
This miter saw employs positive stop function. You can
set 0°, 15°, 22.5°, 31.6°, and 45° right/left miter angle
quickly. To use this function, move the turn base close
to your desired positive stop angle while holding up the
lock lever. Then release the lock lever and move the
turn base to your desired positive stop angle until the
turn base is locked.
11 ENGLISH
3
1
2
Publicité
