Publicité
Adjusting the bevel angle
CAUTION:
After changing the bevel angle,
always secure the arm by tightening the lever
clockwise.
NOTICE:
Always remove vertical vise before
adjusting the bevel angle.
NOTICE:
When tilting the circular saw blade, be
sure that the carriage is fully raised.
NOTICE:
When changing bevel angles, be sure
to reposition the kerf boards appropriately as
explained in the section for positioning kerf
boards.
NOTICE:
Do not tighten the lever too hard. Doing
so may cause malfunction of the locking mecha-
nism of the bevel angle.
Tilting the circular saw blade to the
left 0° - 45°
1.
Rotate the lever counterclockwise.
2.
Hold the handle and tilt the carriage to the left.
3.
Align the pointer with your desired angle in the
bevel angle scale.
4.
Tighten the lever clockwise to secure the arm.
2
Fig.19
► 1. Lever 2. Handle 3. Pointer 4. Bevel angle scale
4
3
1
Tilting the circular saw blade beyond
the left 0° - 45°
1.
Rotate the lever counterclockwise.
2.
Hold the handle and set the carriage at 0° for right
2° side, or 45° for left 47° side.
3.
Tilt the carriage slightly to opposite side.
4.
Push the releasing button.
5.
Tilt the carriage to the desired position beyond the
range 0° - 45°.
6.
Tighten the lever clockwise to secure the arm.
When tilting the carriage to the right 2°
1
3
Fig.20
► 1. Lever 2. Handle 3. Releasing button
12 ENGLISH
2
Publicité
