IKEA VINTROSA Mode D'emploi page 15

ENGLISH
Cycle
(POTS & PANS)
(Normal Wash)
(China Crystal)
60'
(Quick Wash)
(Energy Saver)
(Rinse Only)
Smart wash system
Your dishwasher has a smart wash system under
the Normal Wash program which selects the wash
cycle based on how large and how soiled the load,
permitting your dishwasher to clean more efficiently
every time. When a partial load of lightly soiled
dishes is placed in the unit, a short wash cycle is
automatically selected. When a full load of heavily
soiled dishes is placed in the unit, a heavy wash cycle
is automatically selected.
Wash cycle selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to activate
dishwasher detergent and melt fatty food soils.
An automatic sensor checks the incoming water
temperature and, if it is not hot enough, the timer will
be delayed to allow for the water to heat for the main
wash of all cycles. This happens even when Hi-Temp
Wash is selected, so that higher temperature will be
available to handle heavier soil loads.
Starting a programme
CAUTION!
Do not remove the baskets
from the dishwasher before a wash cycle.
1. Keep the appliance door ajar.
2. To select a desired programme, press the related
programme button.
The programme indicator turns on and the display
shows the programme duration.
3. Press the function button to select desired
function. The function indicator turns on.
4. Press START/Reset.
Soft Water
(0-3 grains)
5 tsp. (main wash
2 tsp. (main wash
cup filled to line
cup 1/4 full)
No detergent
Medium Hard
Water
(9-12 grains)
(4-8 grains)
8 tsp. (main wash
cup completely full)
above regular)
No detergent No detergent
5. Close the appliance door within 4 seconds to start
the programme. (The cycle indicator begins to
blink and the function indicator stays on.)
Note: If you don't close the door within 4 seconds
after pressing START/Reset, the dishwasher pauses.
Press START/Reset again to continue with the cycle.
Starting a programme with delay start
1. Select a programme.
2. Press repeatedly until the display shows the
delay time you want to set (from 1 to 24 hours).
3. Press START/Reset once, then close the door
within 4 seconds. The delay begins to count down.
4. When the countdown is completed, the
programme starts.
Notes:
•
If you open the door while delay is running, press
the START/Reset, then close the door within 4
seconds to begin the cycle from that point.
•
To cancel the delay and begin the cycle before
the delay period is complete, open the door, then
press and hold START/Reset for 3 seconds.
Cancelling the programme
To cancel a running cycle, slightly open the door,
then press and hold START/Reset for 3 seconds. The
dishwasher will return to standby status.
Hard Water Very Hard Water
(over 12 grains)
Main wash cup
completely full
(water softener
recommended)
No detergent
15