Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Problem
The dishes are not
drying enough
Spots and filming on
dishes
Etching
Detergent left in
dispenser cup
The detergent
dispenser will not
close
Water remains in the
dishwasher.
The dishwasher does
not drain properly.
Suds in the tub
The dishwasher leaks
There are black or
gray marks on the
dishes
The interior of the tub
is stained
Possible cause
The rinse aid dispenser is
empty or the setting is too
low.
Dishes are loaded
improperly.
The cycle you chose did not
include drying.
Water hardness is too high
Dishes are loaded
improperly.
Old or damp rinse aid power
is used.
The rinse aid dispenser is
empty or the setting is too
low.
Using too much detergent.
The inlet water temperature
exceeds 150°F (65.6°C).
Detergent may be too old.
The spray arm is blocked.
Improper operation of the
detergent cover.
The previous cycle has
not finished or has been
interrupted.
The drain is clogged.
The drain hose is kinked.
Using improper detergent.
Excessive suds caused by
using improper detergent.
The dishwasher is not level.
Aluminum utensils have
rubbed against the dishes.
Coffee or tea stains.
Reddish stain.
Possible solution
Fill the rinse aid dispenser. Increase the rinse aid
setting.
Reload the dishwasher as shown in "Preparing and
loading dishes".
Choose a cycle with drying.
For extremely hard water, install a water softener.
Reload the dishwasher as shown in "Preparing and
loading dishes".
Use fresh, liquid rinse aid.
Fill the rinse aid dispenser. Increase the rinse aid
setting.
Use less detergent if you have soft water.
Lower the inlet water temperature.
Use fresh detergent.
When you load the dishes, make sure that the spray
arms are not blocked.
Add detergent and rinse aid only as indicated in this
manual. See "Filling the detergent dispenser" and
"Filling the rinse aid dispenser".
Make sure that the current cycle is finished.
Check the air gap (if so equipped). Make sure that the
disposer is empty (if so connected).
Make sure that the drain hose is not kinked and is
properly connected.
Make sure to use only automatic dishwasher
detergent.
Make sure to use only automatic dishwasher
detergent.
Level the dishwasher (refer to the separate Installation
Manual).
Make sure that the water inlet temperature is not less
than 120°F (49°C).
Use a spot cleaner to remove the stains.
Some tomato products may cause this. Use of the
rinse only cycle right after loading will help this.
21
Publicité
