Nakayama PC4600 Mode D'emploi page 12

EN
Troubleshooting
Case 1. Starting failure
Make sure the icing prevention system is not working.
Check fuel for water or substandard mixture.
Check for engine flooding.
Check the spark.
Case 2. Lack of power / Poor acceleration / Rough idling.
Check fuel for water or substandard mixture.
Check air filter and fuel filter for clogging.
Check carburettor for inadequate adjustment.
Case 3. Oil does not come out
Check oil for substandard quality.
Check oil passage and ports for clogging
When your unit seems to need further service, please consult with our service shop in your area.
Technical Data
Model PC4600 PC5600
Displacement 45cc
Power 2,45hp
Bar Length 45cm
0.325'',
Chain
1,3mm
12
* The manufacturer reserves the right to make minor changes to product design and
technical specifications without prior notice unless these changes significantly affect the
PC6700
performance and safety of the products. The parts described / illustrated in the pages of
the manual that you hold in your hands may also concern other models of the manufac-
50cc 56.3cc
turer's product line with similar features and may not be included in the product you just
2.6hp 3.8hp
acquired.
50cm 55cm
* To ensure the safety and reliability of the product and the warranty validity, all repair,
inspection, repair or replacement work, including maintenance and special adjustments,
0,325'' 0,325''
must only be carried out by technicians of the authorized service department of the
1,5mm 1,5mm
manufacturer.
with non-provided equipment may cause malfunctions or even serious injury or
death. The manufacturer and the importer shall not be liable for injuries and
damages resulting from the use of non-conforming equipment.
WWW.NIKOLAOUTOOLS.COM
Replace with proper fuel.
Remove and dry the spark plug.
Then pull the starter again with no choke.
Replace with a new plug.
Replace with proper fuel.
Clean.
Replace speed needles.
Replace.
Clean.
* Always use the product with the supplied equipment. Operation of the product