Vortice HRI Serie Notice D'emploi Et D'entretien page 11

ENGLISH
Condensate drain
During normal operation, condensate collects at the
bottom of the apparatus, inside a double tray which has
two drainage outlets; the connection points are located
at the side of the appliance (fig.2). The condensate drain
can be created by connecting the drain outlets to two
flexible hoses with an internal diameter of approximately
19 mm.
2 2
2b 2b
To prevent air bubbles from forming, make a siphon with
each of the two tubes, as illustrated in fig. 2b. Cut the
tube end diagonally.
NOTE
Both siphons must be created in accordance with the
measurements provided in fig. 2c; otherwise appliance
operation will not be guaranteed
A condensate drain can also be created using the
household drainage system.
2a 2a
2c 2c
∆
h > 50 mm
≥ 60 mm
11