Installation; Installing The Sounder - Abus Secvest Instructions D'installation Et D'utilisation

Installation

Installation

Installing the sounder

Step 1: Select installation location for the sounder
Select an installation location which:
 is inaccessible to intruders and vandals
 is located well out of reach (>3 m)
 is clearly visible, so that it acts as a strong deterrent
 is within the wireless range of the alarm panel (max. 500 m outdoors).
Note
The wireless signal strength should be tested using the test box at the installation loca-
tion for the sounder and the alarm panel prior to installation.
The sounder must not be installed in the following locations:
 at a distance of less than 1 m from large metal structures such as metal doors or frames,
water tanks, refrigerators or cars
 at a distance of less than 1 m from household electrical systems, distributors or metal pipes
 inside metal housings
 close to high-voltage devices or electronic devices such as computers, photocopiers or
other wireless devices
Step 2: Open the sounder's cover
 Open the two covers for the two lid-fixing screws (see Fig. 1).
 Remove the fixing screws and open the cover.
Step 3: Configure the sounder's jumpers
 Remove the jumper/connector cover (see Fig. 1) by pushing the two fixing tabs (see Fig. 1)
outwards and lifting up the cover at the same time.
 Set all the jumpers in the sounder to the desired positions (see Fig. 3).
28 | EN