Hypertherm Powermax45 XP Mode D'emploi page 9

7. Route the J1 connector
Route the cable between the fan and the solenoid valve. Plug the J1 connector into J1
RS-485 board.
1
7
Do not put the RS-485 serial interface cable below the fan. This can cause the wires to be pinched by
the fan. If any wires get pinched by the fan, this can damage the wires and prevent the fan from
operating correctly.
8. Attach the rear panel connector
(6 inch·pounds).
Powermax45 XP and Powermax45 SYNC
on the longer cable through the mounting hole in the rear panel.
6
NNOTICE
using 2 screws. Tighten the screws to 7 kg∙cm
7
Field Service Bulletin 809930
RS-485 Serial Interface Receptacle with PCB
4
5
3
6 2
on the
6
9