Hypertherm Powermax45 XP Mode D'emploi page 4

RS-485 Serial Interface Receptacle with PCB
Kit 428654 contents
1
Item Part number
1
2 229765
3
4 141109
5 075418
Remove the plasma power supply cover and component barrier
1. Set the power switch to OFF (O), disconnect the power cord from the power source, and
disconnect the gas supply.
2. Remove the 2 screws from the power supply handle
handle to remove the screws.
4
2
5
Description
RS-485 serial interface cable
Ground wire
Interface cable (J11)
RS-485 serial interface PCB
Screw: #4 X 1/4, pan head
WARNING
STORED ENERGY HAZARD
You can get a serious electric shock from the uncontrolled release of stored
energy in capacitors. Electric shock can seriously injure or kill you.
Before you remove the plasma power supply cover, disconnect electrical
input power and wait 1 minute to allow stored energy to discharge.
809930
4
. You may need to gently pull up on the
1
Field Service Bulletin Powermax45 XP and Powermax45 SYNC
3
Quantity
1
1
2