Hypertherm Powermax45 XP Mode D'emploi page 6

RS-485 Serial Interface Receptacle with PCB
5. Remove the two plastic pins
Slide the component barrier off.
4
6. Optional - to gain better access to the inside of the front and rear panels, disconnect them from
the plasma power supply.
a. Use a TORX screwdriver to remove the 2 screws
b. Use a blade screwdriver to push in the 2 tabs
the panels disconnect from the base.
5
6
that secure the component barrier to the main power PCB.
4
4
6
6
809930 Field Service Bulletin
from the front and rear panels.
5
at the bottom of each of the panels until
6
Powermax45 XP and Powermax45 SYNC
5