Hypertherm Powermax45 XP Mode D'emploi page 10

RS-485 Serial Interface Receptacle with PCB
Install the plasma power supply component barrier and cover
1. Reconnect the front and rear panels to the plasma power supply if necessary.
2. Put the ground clip
ground clip is connected to the ground wire.
3. Attach the component barrier to the power PCB with the 2 plastic pins
10
WARNING
SHOCK HAZARD
You can get a serious electric shock if you touch exposed plasma power
supply components. Electric shock can seriously injure or kill you.
You must install the component barrier and the plasma power supply cover.
Never operate the plasma power supply unless the component barrier and the
plasma power supply cover are in position.
into position to align with the screw from the handle. Make sure that the
1
1
2
809930 Field Service Bulletin Powermax45 XP and Powermax45 SYNC
.
2