Options And Accessories - Hatco Glo-Ray GRN4 Série Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

English

Non-Adjustable Tubular Stands

Tubular stand mounting permanently attaches the unit to a

countertop or serving table. All wiring may be concealed within

one of the tubular stands.

Ensure safe and proper operation. Refer to the "Installation

Site Requirements" listed in the INSTALLATION section of

this manual.

Aluminum, non-adjustable tubular stands are available in

heights of 10", 12", 14", and 16" (254, 305, 356, and 406 mm).

NOTE: Tubular stands cannot be retrofitted in the field.

NOTE: If wiring is to be concealed, a 1" (25 mm) diameter hole

must be provided in the mounting surface centered

under the stand containing the wire leads.

(25 mm)

Distance from end of unit to center of conduit hole.

Needed for 1" (25 mm) diameter

hole cutout in mounting surface.

Countertop Conduit Hole Dimension

1. Position the unit upside-down on a flat surface.

NOTE: Units for this application are supplied with the conduit

attached to one side of the unit. Conduit should not be

removed.

2. If applicable, route the flexible conduit through the center

of one of the stands.

3. Pull the conduit-side stand up against the unit and secure

the stand to the unit using the screws supplied. Align the

other stand with the mounting holes at the other end of

the unit and secure the stand to the unit using the screws

supplied.

4. If applicable, route the flexible conduit through the 1"

(25 mm) diameter hole cut into the mounting surface.

5. Secure the stands to the mounting surface.

Form No. GRN4M-1017

CAUTION