Publicité
Les langues disponibles
Les langues disponibles
How to Use
EN
Vacuum and Mop
Note: When using the mop assembly for the first time, the robot performs the
"Vacuum and Mop" task by default.
1. Start cleaning
Press the button
on the robot, or use the app to make the robot start from
the base station. Then the robot will plan the optimal cleaning route and
perform the cleaning task based on the created map.
Note:
·
To ensure the robot easily returns to the base station after cleaning, it is
recommended to make the robot start from the base station.
·
The mop pads will be cleaned before the robot starts mopping, please wait
patiently.
·
Do not move the base station, the clean water tank, the used water tank, or
the washboard during operation.
·
Hot water cleaning can be enabled in the app for mop pad and washboard
base cleaning tasks, which applies to all modes. To prevent scalding, do
not touch the water outlet when the function is on.
14
2. Auto mop washing
When cleaning, the robot will automatically return to the base station to wash
mop pads based on the mop pad cleaning frequency specified in the app.
The base station will automatically refill the robot's water tank and the robot
will resume cleanup.
How to Use
3. Automatically empty the dust box and wash and dry the mop
pads
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically start emptying the dust box. Then
it will wash and dry the mop pads.
Note:
·
If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust box.
·
The base station will empty the dust box according to the setting in the app.
4. Clean the used water tank
After the robot has completed its task, please clean the used water tank to
prevent any odor.
Mop after Vacuuming
Enable the mopping after vacuuming function in the app, and the robot will
automatically remove the mop assembly on the base station to vacuum the
floor. After vacuuming is completed, the robot will return to the base station
to install the mop assembly and the base station will automatically start
emptying the dust box. And then, the robot will start mopping after the main
brush and side brush are raised.
Vacuum Only
Enable the vacuuming function in the app, and the robot will automatically
remove the mop assembly on the base station and start vacuuming.
Mop Only
Enable the mopping function in the app, and the robot will automatically check
if the mop assembly is installed on the base station. If not, the robot will install
the mop assembly and start mopping after the main brush and side brush are
raised.
EN
15
Publicité
