Publicité
Les langues disponibles
Les langues disponibles
Connecting with the Dreamehome App
EN
1. Download the Dreamehome App
Scan the QR code on the robot, or search "Dreamehome" in the app store to
download and install the app.
QR Code
Note:
·
Only 2.4 GHz Wi-Fi is supported.
·
Due to upgrades in the app software, the actual operations may differ from
the directions in this manual. Please follow the instructions based on the
current app version.
12
2. Add Device
Open the Dreamehome app, tap "Scan QR code to connect" , and scan the same
QR code on the robot again to add the device. Please follow the prompts to finish
the Wi-Fi connection.
Note: If you want to reset Wi-Fi, repeat step 2 and then follow the prompts to
finish the Wi-Fi connection.
Wi-Fi Indicator
· Blinking slowly: To
be connected
QR Code
· Blinking quickly:
Connecting
· On: Connected
How to Use
Turn On/Off
Press and hold the button
for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the base station, the
robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the base station and press and hold the button
for 3 seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Pause/Sleep
When the robot is running, press any button to pause it. If the robot is paused
for more than 10 minutes, it automatically enters sleep mode. All indicators on
the robot will turn off. Press any button on the robot, or use the app to wake up
the robot.
Note: If the robot is paused and placed onto the base station, the current
cleaning process will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the base station
to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please enable it in the app.
Do Not Disturb (DND) Mode
When the robot is set to the Do Not Disturb (DND) mode, the robot will be
prevented from resuming cleaning and the power indicator goes out. The DND
mode is disabled by default at the factory. You can use the app to enable the
DND mode or modify the DND period. The DND period is 22:00-8:00 by default.
Note:
·
The scheduled cleaning tasks will be performed as usual during the DND
period.
·
The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press briefly the button
to enable the spot
cleaning mode. In this mode, the robot cleans a square-shaped area of 1.5 ×
1.5 meters around it and returns to its starting point once the spot cleaning is
completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the
button
for 10 seconds to forcefully turn it off. Then, press and hold the
button
for 3 seconds to turn the robot on.
EN
13
Publicité
