Parkside PHSL 900 A3 Traduction Des Instructions D'origine page 31

may suffer from allergies caused by
the material when it comes into contact
with the skin. If this happens, remove
the glasses immediately and seek
medical attention
• Safety goggles worn over prescription
glasses can be a hazard due to trans-
mission of shocks.
• Clear glasses offer no protection
against glare from the sun.
• These goggles do not protect against:
high impact / laser radiation / infec-
tious material / explosives / molten
metal / chemical splashes / welding
radiation, etc. If any of these hazards
apply, you must use additional suitable
protective equipment
• If S, F, B, and A symbols on lenses do
not match the ones on the frames, the
lower of the symbols must be adopted as
the factor for the overall eye protection.
The letter T immediately after the
strength symbol allows the use for high-
energy particles with extremely high
temperatures. If the T-designation is miss-
ing, ambient temperature is assumed.
Safety goggles
This eye protection meets the safety requi-
rements of the European Regulation (EU)
2016/425 regarding individual protective
equipment and is manufactured according
to standard DIN EN 166:2001.
Intended Use
This product is intended for domestic use
as safety goggles in connection with cut-
ting and trimming hedges, bushes, and
ornamental shrubs. Any other use not ex-
pressly permitted in this instruction manual
may result in damage to the safety goggles
and may pose a serious risk to the user.
Technical Specifications
Safety goggles ...................SG0031
Material ..................... polycarbonate (PC)
Optical class ...................................... .1
Protection class ................................... .S
Side shielding ....................................yes
Product lifetime .................max. two years
Operating conditions
.................-5 to +55 ºC (23 ºF to 131 ºF),
.......................................... 40 – 80% rF
Storage conditions
.................. .5 to +35 ºC (41 ºF to 95 ºF),
.......................................... 40 – 70% rF
Transportation
The eye protection should be transported
in the original packaging or a similar, sui-
table protective cover.
Cleaning and Maintenance
- the safety goggles must be cleaned
with mild soap and lukewarm water
- dry the goggles with a clean cotton
cloth.
- disinfect the safety goggles frequently,
but do not use solvents.
Maintenance and storage of
the safety goggles
If the goggles are scratched or damaged,
replace the entire item. We recommend
storing these safety goggles in an appro-
priate protective cover when you are not
using them.
Assembly of the pole
saw
Pull out the power plug before carry-
ing out any work on the equipment.
GB IE
31