Parkside PHSL 900 A3 Traduction Des Instructions D'origine page 34

GB IE
• To avoid eye injuries, always wear the
supplied safety goggles while working
with the hedge trimmer (22).
• Always hold the equipment firmly in
both hands, with one hand on the rear
handle and the other on the front han-
dle (13). Thumbs and fingers must be
firmly around the handles.
• Check the shoulder strap (19) on a
pleasant position, which makes it easier
for you to hold the hedge trimmer.
• Switch off the equipment immedi-
ately in the event that the blades are
blocked by solid objects, pull out the
power plug then remove the object.
• Always work away from the mains
power outlet. Set the cutting direction
before starting work. Ensure that the
power cable is kept well away from
the working area. Never lay the cable
over the hedge, where it could easily
be caught up in the trimmer blades.
• Avoid overstraining the equipment dur-
ing work.
Pull out the power plug im-
mediately if the cable is
damaged, badly twisted
or has been completely cut
through.
A
Putting down the device
• Place the device on the ground with
the motor housing first.
• The safety cutter bar (1) must be
placed on the ground without being
subjected to any pressure.
• Do not apply any static pressure what-
soever to the cutter bar (1).
34
Swivelling the Arm
E
Caution!
The gear box (2) becomes hot
during operation. There is a risk
of burns. Do not touch the gear-
box housing (2) or the connecting
point to the front tubular shaft (6).
1. Release the indexing by pushing the
safety slide (14) forward.
2. The tubular shank can now optionally
be turned 45° / 90° to the right or the
left (see the scale on the device).
3. The safety lock (14) must engage again
before you can use the appliance
safely.
Cutting Techniques
• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables cut-
ting in both directions or, with a swing-
ing action, from one side to the other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge, so
that cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
Application examples:
Please observe the illustrations on
the back fold-out page for applicati-
on examples.
vertical cutting