Shure BLX88E Mode D'emploi page 16

BLX
Working Range
91 m (300 ft) Line of Sight
Note: Actual range depends on RF signal absorption, reflection and
interference.
Audio Frequency Response
50 to 15,000 Hz
Note: Dependent on microphone type
Total Harmonic Distortion
Ref. ±33 kHz deviation with 1 kHz tone
0.5%, typical
Dynamic Range
100 dB, A-weighted, typical
Operating Temperature
-18°C (0°F) to 57°C (135°F)
Note: Battery characteristics may limit this range.
Polarity
Positive pressure on microphone diaphragm (or positive
voltage applied to tip of WA302 phone plug) produces
positive voltage on pin 2 (with respect to pin 3 of low-
impedance output) and the tip of the 1/4-inch output.
BLX1
Audio Input Level
gain max
min (0 dB)
Gain Adjustment Range
26 dB
Input Impedance
1 MΩ
RF Transmitter Output
10 mW, typical
varies by region
Dimensions
110 mm x 64 mm x 21 mm (H x W x D)
Weight
75 g (2.6 oz.), without batteries
Housing
Molded ABS
Power Requirements
2 LR6 AA batteries, 1.5 V, alkaline
Battery Life
8
up to 14 hours (alkaline)
English
BLX2
Audio Input Level
Gain Adjustment Range
RF Transmitter Output
Dimensions
Weight
Housing
Power Requirements
Battery Life
BLX4 & BLX88
Output Impedance
-16 dBV maximum
+10 dBV maximum
Audio Output Level
Ref. ±33 kHz deviation with 1 kHz tone
RF Sensitivity
Image Rejection
Dimensions
Weight
Housing
Power Requirements
gain 0dB
-10dB
10 dB
10 mW, typical
varies by region
224 mm X 53 mm dia. (8 7/8 X 2 1/8 in.)
218 g (7.7 oz.) (without batteries)
Molded ABS
2 LR6 AA batteries, 1.5 V, alkaline
up to 14 hours (alkaline)
XLR connector
6.35 mm (1/4") connector
XLR connector
6.35 mm (1/4") connector
-105 dBm for 12 dB SINAD, typical
>50 dB, typical
BLX4 40 mm X 188 mm X 103 mm (H x W x D)
BLX88 40 mm X 388 mm X 116 mm (H x W x D)
BLX4 241 g (8.5 oz.)
BLX88 429 g (15.1 oz.)
Molded ABS
12–15 V DC @ 160 mA (BLX88, 320 mA), supplied by
external power supply (tip positive)
-20 dBV maximum
-10 dBV maximum
200 Ω
50 Ω
–27 dBV (into 100 kΩ load)
–13 dBV (into 100 kΩ load)