Publicité
Les langues disponibles
Les langues disponibles
Transmitter LED Indicators
LED Indicator
Green
Rapidly Flashing Red
Solid Red
Flashing Red and shuts off
*For alkaline batteries only. For rechargeable batteries, solid red means the batteries are dead.
Single System Set Up
Before you begin, turn off all transmitters and turn on any equipment (other microphones or personal monitoring systems)
that could cause interference during the performance.
group
(A-Y)
Setting Transmitter Group and Channel
Transmitter group and channel must be manu-
ally set to match the receiver.
Group (letter)
1. Press and release the group button on the
transmitter to activate the display. Press the
group button again and the display flashes.
2. While the display is flashing, press the
group button again to advance to the de-
sired group setting.
Channel (number)
If channel needs to be changed, follow the
same procedure using the channel button
instead of the group button.
Note:
•
When the group and channel correctly
match the receiver, the ready LED on
receiver illuminates.
•
After manual setup, the transmitter
alternately displays the group and channel
setting for about two seconds.
English
Status
Ready
Controls locked
Battery power low (less than 1 hour remaining*)
Batteries dead (change batteries to power on transmitter)
1. Press and release the group button on the receiver.
The receiver scans for the clearest group and channel.
Note: If you want to stop the scan, push the group button again.
2. Turn on transmitter and change the group and channel to match the
receiver (See Setting Transmitter Group and Channel).
Once the system is set up, perform an audio check and adjust the
gain if necessary.
group
channel
group
group
group
group
channel
channel
channel
3
Publicité
