Publicité
Les langues disponibles
Les langues disponibles
•
Dispose of the equipment with the
battery discharged. Do not open the
equipment or the battery.
•
Dispose of the equipment in ac-
cordance with the local regulations.
Take the equipment to a collection
point,where it will be recycled in an
environmentally friendly manner. For
information about this, ask your local
waste management company or our
service centre.
•
Throw the cut grass on the compost.
Do not throw it in the normal house-
hold waste.
•
Defective units returned to us will be
disposed of for free.
Spare parts/Accessories
Spare parts and accessories
can be obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre (see "Grizzly
Service-Center").
Technical Specifications
Cordless lawnmower.......ARM 2433-21
Motor voltage
.....................24 V
Idling speed .............................3650 min
Cutting circle ............................... 330 mm
Cut height .............................. 25 - 65 mm
Protection class .................................... III
Protection type................................. IPX1
Weight
(without battery and recharger) ...... 10 kg
Lawn bag volume .............................. 32 l
Sound pressure specification
(L
) .........................78.8 dB(A); K
pA
Noise level specification (L
measured..........89.1 dB(A); K
guaranteed ................................ 91 dB(A)
Vibration (a
) ..........1.45 m/s
h
3,0 Ah
-1
=3 dB
pA
)
WA
=2.17 dB
WA
; K=1.5 m/s
2
2
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched
on but running without any load).
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be car-
ried out in the course of further develop-
ment without notice. All dimensions, refer-
ences and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the ba-
sis of the instruction manual, cannot thus
be considered as valid
GB
27
Publicité
