Publicité
Les langues disponibles
Les langues disponibles
GB
When both wing nuts (2b) are loos-
ened, the curved handle can be
folded down for storing the equip-
ment. Ensure that the power cable
A
(
13) is not caught.
Installing the grass box
D
1. Insert the handle (4a) of the
grass catcher box (4) into the
bracket on the upper side of the
lid. They click into place.
2. Pull the plastic straps over the
linkage tubes.
Attention: Do not operate the ap-
pliance until the collision guard
and grass box are fully installed.
Risk of injury!
Operation
The mower must only be set
when the motor is switched off
and the blades are shut-down.
There is a risk of personal injury.
Switch of the device, pull the ig-
nition key (12) and wait for the
blades to come to a stop.
Mounting/removing the grass
box
1. To mount the grass catch box
E
(4) lift the impact protection (5)
and mount the grass catcher
box (4).
2. Lower the collision guard (5)
onto the grass box (4) - it will
keep it in place.
24
3. To remove the grass box (4),
lift the collision guard (5) and
unhook the grass box from the
mounting bracket. Flap down
the collision guard to the hous-
ing (9).
Adjusting the Cut Height
There are 5 different cutting heights:
65 mm - large cutting height
55 mm - medium cutting height
45 mm - medium cutting height
35 mm - low cutting height
25 mm - low cutting height
F
1. Hold the cutting height adjuster
(7) and move it to the correct
cutting height, as appropriate.
The correct height is around 25 – 45 mm
for a decorative lawn and around
45 –65 mm for a used lawn.
A higher cut height should be
selected for the first cut of the sea-
son.
Observe noise control and local
regulations.
Insert/remove battery
Switch off the device, pull the
ignition key (12) and wait for the
blades to come to a stop. There is
a risk of personal injury.
G
1. To insert the battery (11) into the
device, push the battery along
the guide rail into the device. It
locks into place audibly.
Publicité
